RCA pcstuff PC7320 Manual De Instalación página 3

PC7320_NA_IB_REVA 10/10/03
Installation Guide (Continued)
For USB mouse installation, you should run SETUP.EXE once before or after you
connect the mouse.
Windows® 2000
1. Click on the "Start" button and point to "Settings."
2. Click on the "Control Panel."
3. Double click on the "Mouse" icon and display "Mouse Properties."
4. Click on the "Hardware" tab in the "Mouse Properties" dialog box.
5. Choose the mouse you want to install from the "Devices:" list and then click on the
"Properties" button.
6. Click on the "Driver" tab in the showing dialog box.
7. Click on the "Update Driver..." button and display the "Upgrade Device Driver Wizard."
8. Click on the "Next>" button and display "Install Hardware Device Drivers."
9. Choose "Display" a list of the known drivers for this device so that you can choose a
specific "driver," item and then click "Next."
10. Click on the "Have Disk..." button and display "Install From Disk." Insert this disk and
change "Copy manufacturer's files from" to this directory (e.g., "D:\") and then click
the "OK" button.
11. Click on the "OK" button after displaying "Select a Device Driver" with the supported
items and selecting the appropriate one.
12. Follow the instructions on the screen to complete the driver update procedure.
Uninstall
Windows® 98
1. In "Control Panel," open "Add/Remove Programs."
2. In "Install/Uninstall" tab, select this software from the list and click on the
"Add/Remove" button.
3. Follow the instructions on the screen to complete the uninstall procedure.
4
All manuals and user guides at all-guides.com
2:47 PM Page 4
Troubleshooting
1. Check the batteries to ensure they are fully charged.
2. Check the receiver's USB connection. Be sure the receiver is securely connected to the
USB port.
3. If your mouse (model PC7310 or PC7330) does not respond properly, you may need to
change the frequency on which the item is operating. On model PC7330, press the learn
button on the receiver, then press the ID button on the mouse. On model PC7310, make
sure both your receiver and mouse are set to channel 1 or channel 2, and that both are on
the same channel.
4. Make sure the USB port is properly configured in the system BIOS (either "enabled" or
"disabled"). Refer to your computer's documentation for correct port configuration. You
may also have other system device conflicts. Please change the settings as required.
Special Instructions For PC7330
Making the wireless radio frequency connection:
1. Press the "ID" button on the bottom side of the receiver, until the "Status" LED slowly
flashes. (approximately 1-2 seconds)
2. Press the "ID" button located on the bottom of the mouse to connect with the receiver.
The "Status" LED on the receiver will begin to flash rapidly. (Approximately 3-5 seconds).
When the rapid flashing has ceased, the mouse is ready to use.
Français
5