Connecting Signals; Controlling Signals - marklin 72760 Manual Del Usuario

Connecting Signals

Plug the 2-pin socket on the signal (red/brown) into the 2-pin
contact on the back of the control box.
Fig. 3
          
         
Example

Controlling Signals

The signal is controlled by pressing on the button. If the
green LED is on at the button on the control box, the signal
will display "go".
10
Connections as desired.
Assignment to the button and
address is automatic.
Signal aspect
If the LED is off, the signal shows "Stop".
Other Possible Signal Aspects and Their Assignment.
Multi-aspect signals can be assigned to only one control box.
Two (2) buttons (addresses) are required. After setting the
basic address, the signal assigns on its own the sequential
address. The following button combinations (addresses) are
possible, 1 + 2, 2 + 3, or 3 + 4.
Signal aspect
Signal aspect
Signal aspect