Installing Updates For The Home Connect Software; Resetting Home Connect Settings; Data Protection - Bosch KGB Serie Manual Del Usuario

en Home Connect
Place the router and refrigerator
‒
closer together.
Ensure that the connection is
‒
not interfered with by screening
walls.
Install a repeater to strengthen
‒
the signal.
1.3 Installing updates for the
Home Connect software
The appliance searches for updates
to the Home Connect software at reg-
ular intervals.
Note: If updates are available, the
temperature display (refrigerator
compartment) shows
To reset the update and the temper-
ature display (refrigerator compart-
ment) to the set temperature, press
any touch field.
Press +
1.
same time.
a The temperature display (refriger-
ator compartment) shows
Press repeatedly until the tem-
2.
perature display (refrigerator com-
partment) shows
perature display (freezer compart-
ment) shows
Press .
3.
a The temperature display (freezer
compartment) shows an animation.
a The update is installed.
a The control panel is locked during
the installation.
a If the installation is successful, the
temperature display (freezer com-
partment) shows
If the temperature indicator (freezer
4.
compartment) shows
ance was unable to install the up-
date.
Repeat the process at a later
‒
point.
28
.
at the
.
and the tem-
.
.
, the appli-
If the update cannot be completed
5.
after several attempts, contact cus-
tomer service .
1.4 Resetting Home Connect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the Home Connect settings.
Press +
1.
same time.
a The temperature display (refriger-
ator compartment) shows
Press repeatedly until the tem-
2.
perature display (refrigerator com-
partment) shows
perature display (freezer compart-
ment) shows
Press .
3.
a The temperature display (freezer
compartment) shows an animation
for 15 seconds.
a The temperature display (freezer
compartment) then shows
a The Home Connect settings have
been reset.
1.5 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
at the
.
and the tem-
.
.