Charging The Battery - SNOWJOE SUNJOE 24V-MDTCR1-LTW Manual Del Operador

Detector de metales inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Charging the Battery

1. Push the push lock buttons on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
Fig. 1
Battery pack
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
3. The battery will take approximately 3 hours to charge. The
battery indicator LEDs will cycle on one by one during the
charging process. Unplug the charger immediately when
the 3 LEDs are all illuminated.
NOTE: Timely recharging of the battery will help prolong
the battery's life. You should recharge the battery pack
when the charge is low.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will irreversibly degrade the battery.
m
CAUTION!
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
Battery lock
button
Assembly
The product must be fully assembled before operation. Do not
use the device when only partially assembled or assembled
with damaged parts. Follow these instructions to assemble the
metal detector.
Pole Assembly
1. Insert the lower pole into either end of the middle pole
until the locking button clicks into one of the holes.
(Fig. 3).
Fig. 3
Battery
indicators
2. Insert the upper pole into the other end of the middle pole
until the locking button clicks in one of the holes.
3. Adjust the length by pressing the locking buttons and
moving them into different holes along the shaft of the
middle pole. Tighten both locking collars once you have
set the desired pole length (Fig. 4).
Fig. 2
Fig. 4
8
FIRE HAZARD. When disconnecting the
This charger does not automatically turn off
Middle pole
Lower pole
Locking
collars
Locking
buttons
Locking button
Locking collar
Upper pole

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido