Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 8
Wall anchors
3. Use 4 ST4x30 screws to fasten the mounting bracket to
the wall with the wall anchors inside the pre-drilled holes
(Fig. 9).
ST4x30 screw
Mounting bracket
4. Slide the heater head on the mounting bracket and make
sure the bracket is inserted fully in the heater head
(Fig. 10).
Fig. 10
Wall anchors
Fig. 9
Wall
Wall-anchor in the
pre-drilled hole
Heater head
Mounting bracket
Wall
5. Fix the assembly by inserting the heating head knob from
the back of the heater head, screw the knob clockwise
until it cannot be turned further (Fig. 11).
Heater head knob
Fig. 11
Operation
NOTE: This infrared heater is designed for spot heating or as
a supplementary heat source. It's not intended to be the main
source of heat during cold months.
Switch On/Off
1. Place the infrared heater on a level and non-combustible
surface. Plug in the appliance to an outlet, making sure
the power supply is same as rated. The indicator light on
the control panel will start flashing, which means it's in
standby status (Fig. 12).
Fig. 12
Control
panel
Plug
2. Press the "I" button on the control panel to turn on the
heater. The indicator light will illuminate and the heater will
start working (Fig. 13).
7
Indicator
light
Publicidad
Tabla de contenido
