Figure 2
Figure 3
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
2. Align mechanism with holes on bottom of seat
Front
of Seat
3. Align armrest with holes on seat cushion and back
4. Slowly lower chair assembly onto the gas lift. Press
cushion with tension knob facing the front of seat.
Use four 1/4 x 3/4" screws (1) to secure. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
cushion and use four 1/4 x 1" screws (2) to secure
loosely. Repeat on opposite side. Once all eight
screws are installed, fully tighten. Insert plastic caps
(3) in holes to cover screws. (See Figure 3)
down on seat cushion to secure. (See Figure 4)
0621 IH-2753