21. Be careful not to spill food, water or other kind of liquid on the supply cord, if you use the adaptor
for the sender/ receiver.
22.Do not cut or modify any of the parts of the adapter. This may cause risk of injuries during the use
of the adapter.
23.Use only the adapters provided by the manufacturer or importer.
24.Do not use the adapter if there is damaged cable or plug.
25.To avoid injury, change the damaged adapter with original one.
26.To avoid electric shock do not open the bodies of the units of the baby monitor.
27.Do not use the appliance if it doesn't work correctly, if it is damaged or if it has been dropped into
water. Contact the shop from which you bought the product or the importer to repair the baby unit.
28.Do not disassemble and do not try to repair the baby unit at home. In case of damage contact an
authorized service center or the importer.
29. Do not use spare parts, which are not the original ones provided by the manufacturer or the
importer.
30.Do not try to modify the product, to repair it by yourself when damaged or to replace any of the
parts with such that are not provided from the manufacturer/ importer. This may lead to its
malfunction or damage.
31.Do not store the baby monitor and its adaptor close to direct heat sources – open fires, heaters or
cookers.
32. WARNING:
-Use and store the appliance under temperatures between 10° to 45° degrees of Celsius.
-Do not expose the sender or receiver to temperatures that are too low or too high and to direct
sunlight.
-Do not use sharp objects or aggressive detergents to clean the appliance.
33.Warning! Risk of suffocation! Keep the nylon packages away from children reach. Small children
should not be present during unpacking the product.
34.Privacy protection:
Do not forget that you are using public airwaves when using the wireless 2.4GHz Digital Baby Monitor.
The sound can be broadcasted to other receiving devices. Conversations, even from rooms near the
baby unit, can also be broadcasted.
35.Warning! To protect your privacy, always turn off the camera and the parent unit, when you are
not using them. The parent unit may receive interference from other devices in the 2.4GHz frequency
band.
36.Do not remove the labels and warnings attached to the product! They are important for everyone
who uses them!
Charging the parent unit (the receiver)
Power supply of the baby unit (sender)
Charging time
Use time after full charge in ideal conditions
TECHNICAL SPECIFICATIONS
Built-in 3.7V 400mAh rechargeable battery
and
Charger:
Input 100V ~ 240V 50/60 Hz; Output 5V, 1A, 5.0W
Built-in 3.7V 400mAh rechargeable battery
and
Charger:
Input 100V ~ 240V 50/60 Hz; Output 5V, 1A, 5.0W
120 minutes
7 hours if constantly working and 20 hours in stand-by mode
11