Lenco DAB-11 Manual Del Usuario página 11

Program Type (PTY): Shows the type and description of the program provided by the DAB station.
Time& Date: Displays the time and date information provided by the broadcaster.
Bit Rate: The date rate of which the signal is being transmitted.
Station information on FM mode
Every time you press the Info/Menu button in the FM mode, the display will cycle through the
following display modes:
Program type: Displays description of the program provided by the radio station.
Signal Strength: Displays a signal bar with the current station strength.
Time and Date: Displays the time and date information provided by the broadcaster.
Frquency: Displays the station's transmission frequency.
Audio Type: Displays the audio type of the current station (Stereo or Mono).
Radio Text: Displays scrolling test information supplied by the broadcaster.
Note: To switch between mono and stereo by pressing the Enter/Snooze button repeatedly.
Retuning your DAB+/FM Radio
You can retune your radio stations to store new stations or tune to a new region. Your preset stations
will remain stored when you perform a full scan retune. In DAB mode:
Press the Scan button to perform a full scan.
Progress will be indicated on the display.
When tuning is complete, the radio will play the first listed station or return to the last station played.
Using the Headphones
You can listen to your DAB/FM radio using headphones, just plug the 3.5mm jack into the back of your
device in the headphone jack. Control the volume by using the Volume knob.
FAQs
Problem
No Power
No sound
Poor reception
Function disturbed
Solution
Check that the system is connected to a working mains outlet.
Check that the DC power adaptor is properly connected to the DC in on the
radio.
Check that the volume control is not at minimum setting.
Adjust the location of the antenna for best signal reception.
If none of the above solution work, try switching off and unplugging your
Radio.
11