Snapper POWER FLOW + SP3200 Manual Del Operador página 9

Check Water Inlet Screen / Connect Garden Hose
1. Inspect inlet screen. Remove debris or replace if
damaged.
Inlet Screen
2. Run water through garden hose (not to exceed 50 ft
(15 m) to clean out debris, then connect to water inlet.
NOTICE There must be at least 10 ft (3 m) of unrestricted
garden hose between the pressure washer inlet and
any device, such as a vacuum breaker, to prevent pump
damage.
3. Turn on water, point spray gun in safe direction, press
trigger lock and depress trigger to purge pump system
of air.
4. Attach spray wand to spray gun. Tighten by hand.
Step 4: 7-in-1 Nozzle
1. Select desired nozzle setting:
High Pressure:
HIgh Flow:
2. Pull spray wand quick connect collar back, insert 7-in-
1 nozzle and release. Tug nozzle to ensure it is secure.
9