Publicidad
Idiomas disponibles
Idiomas disponibles
RV-AMP4.book Seite 23 Dienstag, 31. Oktober 2006 4:20 16
All manuals and user guides at all-guides.com
PerfectView Accessory
When the negative terminal of the battery is disconnected, all volatile memories in the
convenience electronics lose the stored data.
The following data must be set again, depending on vehicle equipment:
–
Radio code
–
Vehicle clock
–
Timer
–
On-board computer
–
Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following instructions during installation:
Secure the parts of the control box in such a way that they cannot become loose
under any circumstances (sudden braking, accidents) and cause injuries to the
occupants of the vehicle.
To prevent damage, when drilling ensure that there is sufficient room for the drill head
to emerge once the hole has been made (see fig. 1, page 3).
Grind all drill holes and treat them with rust-protection agent.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp (see fig. 3.1,
page 4) or a voltmeter (see fig. 3.2, page 4).
Test lamps with an illuminant (see fig. 3.3, page 4) take up voltages which are too
high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
–
They are not kinked or twisted
–
They do not rub on edges
–
They are not laid in sharp edged ducts without protection (see fig. 2, page 3).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
Safety and installation instructions
23
Publicidad
