Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHING PANELS TO POSTS
NOTE: For H-5611-7 8 x 7' panel, use four
included nuts and bolts to attach two panel
halves together.
1.
For a straight run, end to end, use straight bolts and flat
washers. (See Figure 2) Use a 13mm wrench to tighten.
NOTE: Safe installation requires two people.
Figure 2
Bolt Head
Flat Washer
2. For a 90º corner, use curved bolts and lock washers.
(See Figure 3)
Figure 3
Curved Bolt
Lock
Washer
3. For a T-intersection, use curved bolts and lock
washers. (See Figure 4)
Figure 4
1 ¡ ¢
' £ ¤ ¥ ¦ §
PAGE 2 OF 6
INSTALLATION CONTINUED
Straight Bolt
Flange Nut
Panel
Flange Nut
Bolt Head
Bolt Head
4. Attach opposite end of panel to second post.
ATTACHING DOOR TO POSTS
1.
Mount door to post. Doors swing outward, away from
the enclosure. Determine which side to anchor the
door on.
a. If anchoring on the existing post, proceed to
part b. If anchoring on the opposite post, use
the door width to determine the proper mounting
distance and install opposite post. Take care
to measure post to post. Too large of a gap will
prevent the door from functioning properly.
b. Line up the hinges with the pre-drilled holes on
the post. Attach the hinges using the provided
self-tapping screws and nut driver.
NOTE: Use a screw gun with an adjustable
clutch, and take care not to over tighten and
strip the threads. DO NOT USE IMPACT TYPE GUNS.
2. Install hasp. Close the door and slide the bolt out
and across the post. Position the hasp and screw it
into the post using the self-tapping screws.
(See Figure 5)
Figure 5
Post
NOTE: Holes for hasp are not pre-drilled. Apply
pressure with self-tapping screws to puncture
post.
TO COMPLETE ASSEMBLY: Use black plastic plugs to
cover any unused bolt holes in the posts.
1-800-295-5510
uline.com
Bolt
Door
¨ ©
0721 IH-5607
Publicidad
