Wall Mount - Heath Zenith Secure Home 7103 Manual Del Usuario

Mounted Solar Panel
Note: Solar panel should be mounted as shown above
when installed (depending upon type of installation).
After adjusting solar panel, tighten the thumbscrew on
the bottom of the solar panel.
2. Mount Light Fixture. Attach the battery case to a
solid surface using two round-head screws and the
keyholes on the back of the case.
Note: Use the included mounting template to help
mark the mounting hole locations.
Wall Mounted Light
Note: Light fixture and sensor should be mounted as
shown above when installed (depending upon type of
installation).
Angled 50°
roof Mount

Wall Mount

Angled 50°
Mounting
5 / "
3
Holes (2)
4
Solar Panel
Solar Panel
Wire
Light Fixture
Do not Mount under Eaves
3. adjust sensor. For proper operation, the sensor
head must be rotated so that the sensor controls face
downward as shown below.
IMPORTANT: the controls must face downward to
avoid damage from rain. If controls face upward, move
sensor to the original down position, rotate 180°, then
raise to the position shown below.
Light Joint Clamps
Battery Case
Sensor Joint
Clamp
4. Plug the solar panel cable into the bottom of the battery
case. IMPORTANT: allow the battery to charge
with 3 to 7 days of full sunshine before testing. to
verify battery is charged, slide the On-tIME switch
to tESt. Wait 2 minutes for sensor to warm up.
If light comes on when motion is detected after
warm up period, battery is charged and ready for
use. If light does not come on, slide the On-tIME
to OFF. recheck the light the next day.
2
Light
Sensor
Controls
200068-01