Bit Installation - BGS technic 70209 Manual Del Usuario

CHARGING
Make sure that the tool is switched off (the torque indicator is turned off). Please note it is forbidden to use
this tool when in charging.
For the first use of this tool, please fully charge it for 5 hours in order to make battery power well.
1. Plug the USB charging cable into the socket (8) of the tool.
2. Connect the other side of the charging cable to a suitable 5V USB charging adapter.
3. Plug the USB charging device into a wall socket.
4. Charge will start automatically (LED red light will be on).
5. Unplug the tool when the charging is finished.
The charging process is finished when all 5 red LED will be on.
Battery is charging

BIT INSTALLATION

Insert one of the bits, the bit adapter or the automatic bit holder into the output profile.
CLOCKWISE / COUNTER-CLOCKWISE
To unscrew screws, press the
lower part of the switch (5) the
screwdriver will rotate to the left.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Charging is finished
To fix screws, press the
switch (4) on the top and the
screwdriver will rotate to the
right.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed