Maintenance / Cleaning - Deuba DBDL005 Manual De Instrucciones

Maintenance/Cleaning
•
any maintenance or checks.
• Check all parts for signs of wear. If any problems
are detected, do not use the product. Always
replace all parts with original replacements
according to the manufacturer's guidelines.
• If the product is not properly cared for and
maintained, it can become unsafe and can also
become damaged. This can lead to dangerous
• Regular maintenance on the product helps to
make the product safe and will also increase its
lifespan.
• Use a clean, dry cloth to clean the outer surface.
• Make sure that the casing, air inlet and saw
blade are free from debris and dirt.
PROBLEM POSSIBLE CAUSE
The power has 1.
decreased.
2. The trigger is obstructed.
3.
4. Air is leaking through a
loose casing.
5. The mechanism is
contaminated.
The casing gets 1.
hot during use.
2. Worn parts.
There is 1. The casing is loose.
2. The valves and / or casing
leakage (slight are damaged.
air leakage is 3. Valves are dirty / worn /
normal). damaged.
17
www.DeubaXXL.de
• The trigger's pivot point must be cleaned
regularly with a light machine oil.
• Before the hose is connected for use, always
not use cleaning oil!
• Before each use, check that the stop bracket
and saw blade are securely in place, otherwise
•
once a week during regular use.
The following table shows possible faults and
During maintenance, disconnect the device from
the compressed air supply.
SOLUTION
1.
with the required pressure.
2. Clean the area around the trigger.
3.
4.
securely.
5. The mechanism can be cleaned by a technician.
1.
2. The internal mechanism can be checked by a
technician, who may need to replace parts.
1. Tighten the casing. If it cannot be properly
aligned.
2. Replace damaged parts.
3. Clean the valve unit.