Publicidad
Ircana LED
WAS
PRECAUTIONS:
• Keep the product out of the reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not hit the product.
• Do not install the product where there are heat sources or moisture con-
centrations.
• Do not handle the product while it is in operation and allow it to cool
before touching it with your hands.
• The product must not be covered with thermal insulation material under
any circumstances.
• Maintain a minimum distance of 1m from the surface or object to be
illuminated.
• If the product is damaged, replace it immediately with a new one.
• Disconnect power before installing the product.
• This product contains components sensitive to static electricity and a
discharge to it could destroy or damage its components.
• Before carrying out any work or maintenance, make sure that the device
is completely disconnected from the power supply.
• The replacement or maintenance of any component must be carried out
with the same elements recommended and supplied by the manufacturer
himself. If this is not the case, any incident on an installation that has not
been carried out in accordance with this instruction sheet is the responsibility
of the installer.
• The light source of this luminaire should only be replaced by the manufac-
turer or its technical service.
• Between the low voltage power supply and the control conductors the
insulation is reinforced insulation.
• DO NOT TOUCH THE OPTICS.
• IN CASE OF HAVING TO CLEAN LENS USE A DAMP CLOTH. NEVER USE
ISOPROPYL ALCOHOL.
W
LUM
40W
DEGREE OF PROTECTION
Degree of waterlightness
Impact resistance
INSTALLATION
Maximum surface wind exposed
Maximum. Height of installation
1/8
445
Nº LED
WEIGHT
32 LED
10Kg
IP65
IK08
0,310m
2
7m
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
WARNING
BEFORE STARTING THE INSTALLATION OF THIS PRO-
DUCT, PLEASE READ CAREFULLY THE FOLLOWING INS-
TRUCTIONS AND KEEP THERE IN A SAFE PLACE.
THE INSTALLATION MUST BE CARRIED OUT BY QUALI-
FIED STAFF.
IMPROPER HANDLING OF COMPONENTS OR THE OWN FIXTURE
ITSELF MAY DAMAGE THE PROPER OPERATION OF THIS PRODUCT,
CONSEQUENTIALLY THE MANUFACTURER'S WARRANTY WILL BE
VOID.
MANUFACTURER'S WARRANTY WILL BE VOID AUTOMATICALLY IF
THE INSTALLATION DOES NOT FOLLOW THE INDICATIONS OF THE
REBT 2002.
IT IS MANDATORY TO APPLY THE REBT ITC BT09-4 (INSTALLATION
OF THE SURGE PROTECTOR IN LINES AND LIGHTING FIXTURES) FOR
INDUSTRIAL FACILITIES AND PUBLIC LIGHTING. THE WARRANTY
DOES NOT COVER DAMAGES CAUSED BY OVER-VOLTAGE IN
LIGHTING WITHOUT SURGE PROTECTOR.
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE COMPONENTS (LED).
FOR
ELECTROSTATIC
Publicidad
