Rupes DD120LT Manual De Uso página 7

put the plug of the charger into the electrical
outlet which supplies 230 volt, the red and green
light will illuminate which indicating that charging
is taking place, after charging for about 30
minutes, the red light will go out and the green
only will illuminate which indicating the battery
pack is fully charged.
BATTERY REPLACEMENT
- Press the eject buttons while pulling the
tery down until released;
- Use of batteries not suitable for the machine
can lead to malfunctions of or cause damage to
the power tool. Set the rotational direction switch
to the centre position in order to avoid
unintentional starting. Insert the charged battery
5 into the handle so that it can be felt to engage
and faces flush against the handle.
The Li-ion battery is protected against deep
discharging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
4. OVERLOAD PROTECT
When the power is too low or load is overload,
the drill will stop to rotation. The drill still can
rotation when the power is high or load is small.
5. SWITCHING ON AND OFF
To start the machine, press the On/Off switch
and keep it depressed. The light is lit when the
On/Off switch is slightly or completely pressed in
and permits to light the work area when the
lighting conditions are bad. To switch off the
machine, release the On/Off switch.
6. VARIABLE SPEED CONTROL
Simply apply light pressure to the trigger to start
the drill on the slow speed. Increasing the pres-
sure on the switch will increase the speed of the
drill.
7. FULLY AUTOMATIC SPINDLE LOCKING
(AUTO-LOCK)
When the On/Off switch is not pressed, the drill
spindle and thus the tool holder are locked.
This enables screws to be screwed in, even
bat- when the battery is empty and allows for the
machine to be used as a screwdriver.
8. CHANGING
ROTATION
Set the direction of the rotation lever to L (left)
and R (right). Noted that the direction of
the rotation lever is locked when the on-off
switch is activated. The reversing or anti-clockwi-
se operation enables application for tasks such
as loosening or removing screws.
Noted: Do not change the direction of rotation
when the drill running.
9. TORQUE ADJUSTMENTS
This feature allows setting of the torque or tighte-
ning power of your drill/driver and depending on
the application, various levels of driving power
are required. When driving larger screw diame-
ters a higher torque power is required to drive
the screw until it's properly seated. When the
selected torque is reached the chuck will stop
rotating.
Noted: Always stat on the lowest setting. The
Drill symbol gives the highest torque setting and
is used when drilling and for driving larger
screws.
10. GEAR SELECTION, MECHANICAL
Actuate the gear selector only when the machine
is at a standstill.
Two speed ranges can be preselected with the
gear selector.
Gear I: Low speed range; for screwdriving or
working with large drilling diameter.
Gear II: High speed range; for working with
small drilling diameter.
If the gear selector cannot be pushed through to
the stop, lightly turn the drill chuck with drill.
11. BATTERY
INDICATION
The battery charge-control LED indicator
consists of three blue LEDs, and indicates the
charge condition of the battery for a few seconds
when the On/Off switch is pressed halfway or
fully.
DIRECTION OF
CHARGE-CONTROL
THE
LED
7