Bosch Integra SHX68M05UC Instrucciones De Uso página 20

Problem Cause
illing with water
Water Leaks
Incorrect rinse agent seing.
Fascia panel Abrasive cleaner used.
discolored or
marked
Noise during The dishes may not be arranged properly.
wash cycle
Previous cycle has not inished or another cycle has
If fault code (E01 to E30) is indicated on the digital display 3 , irst disconnect the appliance from the power supply. You can
recify certain faults yourself (see following fault descripion), for all other faults please contact customer service and state the
indicated fault E:XX.
Water is let in
at the end of the
"Check water
supply" display
20
All manuals and user guides at all-guides.com
Restricion in the water supply system.
Delay-start is acive.
Door seal could be pulled away from track.
Condensaion vent is blocked.
Improper installaion.
ness of water.
Improper operaion of detergent cover.
Previous cycle has not been inished, reset, or cycle
(E24) Waste water hose is blocked or kinked.
(E25) Waste water pump blocked, cover on the
waste water pump is not locked in posiion
Tap turned of.
Acion
Ensure that the water supply valve (typically located under kitch
en sink) is open and check that the water supply line has no kinks
Refer to the "Canceling or changing the cycle" secion of this
Cancel the delay-start or wait unil delay-start ime completes
(imes out). Refer to the "Delay Start" secion of this manual.
Wrong type of detergent results in suds and leaks. Use only
dishwasher detergents. If suds sill persist, then add one ta
blespoon of vegetable oil at the botom of the dishwasher
Ensure that condensaion vent is not blocked. Refer to "Load
ing Extra Tall Items" in the Preparing and Loading the Dish
washer secion of this manual.
Have proper installaion veriied by qualiied personnel (wa
ter supply, drain system, leveling, plumbing).
Concentrated Lemon juice can reduce the build up of hard
water stains. Run a normal cycle unil it lushes and interrupt
the cycle and then place an 8 oz. cup of the concentrated
lemon soluion on the top rack and inish the cycle. This can
Depending on the hardness of water, adjust the rinse agent dis
penser. Refer to "Adding Detergent and Rinse Agent" secion in this
manual for adjustment.
Use mild detergents with sot damp cloth.
Water circulaion sound is normal, but if you suspect items are
banging into each other or into the spray arms, refer to the "Pre
paring and Loading" secion of this manual for opimal arrange
Refer to "Adding Detergent and Rinse Aid" secion of this man
ual for instrucions on opening and closing the dispenser.
Refer to the "Canceling or changing the cycle" secion of this
Refer to the "Canceling or changing the cycle" secion of this
See Care and Maintenance.
Wait unil programme ends (digital display indicates 0:00) or
implement the "Reset"funcion.
Switch of the appliance and pull out the main plug.
Turn of the tap.
Clean ilter in the supply hose.
Reconnect power supply.