Greenlee TPIR-J Manual De Instrucciones página 6

Operation
1. See the instruction manual supplied with the multimeter (purchased separately).
2. See Typical Measurements for specific measuring instructions.
3. Connect the TPIR-J or TPIR-K to the input terminals of the multimeter. Set the multimeter
to read temperature.
4. Turn the unit on.
5. Test the unit on an object with a known temperature.
• If the unit does not function as expected on an object of known temperature, replace
the battery.
• If the unit still does not function as expected, send the unit to Greenlee for repair.
6. Take the reading from the object being measured.
Notes:
• Do not touch or hold by the front cone of sensor. Temperature readings can be affected by
heat from hands.
• If the object or target temperature is above or below the specified range or battery power is
low, the meter will alternate between displaying a reading and a display code. See Display
Code Descriptions for more information.
Display Code Descriptions
Display Code*
270 °C (518 °F)
or –30 °C (–22 °F)
280 °C (536 °F)
or –45 °C (–49 °F)
–60 °C (–76 °F)
Ambient
temperature
* Values may vary ±5 degrees depending on meter accuracy.
6
All manuals and user guides at all-guides.com
Description
Target temperature is
over or under range
Ambient operating temperature
is over or under range
Battery is low
Unit in warm-up or
sleep mode
Action
Select target within unit's
specifications
Allow unit to stabilize in its
ambient operating range
Replace battery
Restart unit by turning unit
to OFF and then ON.