Address; Setting Default Value; End Of Setup; Check/Alter Parameters - Kübler CODIX 550 Manual Del Usuario

5.6.2 Select address
Menu <–> Selection
press the key to accept
5.7 Setting Default Values
The user has the possibility to set all parameters
back to their default values by using the param-
eter . This parameter
programmed with the value
proceed to the next parameter using the keys,
Menu <–> Selection
press the key to accept the selection
5.8 End of Setup Yes/No?
Menu <–> Selection
press the key to accept the selection

5.9 Check/Alter Parameters

Menu <–> Selection
www.kuebler.com
Example: device address 12
Select digit
Set digit
must be
If you then
Select digit
Set digit
Parameters will be stored -> Operation
Check/alter Parameters
Checking the individual menu items
• after every 2 seconds the menu changes
to Selection
• If the setting is as desired, then switch to the next menu
with key, otherwise, start the set-up again.
then all parameters are reset to their default val-
ues. It is not necessary to finish the program-
ming; a new programming cycle can take place
immediately.
É
Chapter 5.9, 17
17