amzchef AT7010S08 Manual De Instrucciones página 20

●
All furnace covers must be firmly fixed in place and cannot be removed without using special tools.
●
Remove the back of the kitchen equipment to ensure the full circulation of air around the oven.
●
The oven rack must have at least 45 mm rear clearance.
●
Because oven handle and sheet metal parts are easy to cut, installers need to wear gloves for installation.
Installation Instructions
The wiring of oven must be equipped with all-pole disconnection device according to the wiring rules
After installing the appliance, it is necessary to have other methods to disconnect the power supply. The
power supply is disconnected by a contactable plug or by a fixed wiring switch that meets the wiring
requirements.
Important information
The appliance is designed to be permanently installed with a three-pin power cord and may only be connected by
a licensed expert in accordance with the connection diagram.
Only a qualified electrician who takes the relevant regulations into account may replace the power cord.
Do not use multiple plugs, power strips or extensions.Overloading causes a risk of fire.
If the connection is no longer accessible following installation, an all-pin isolating switch with a contact gap of at
least 3mm must be provided.
Connect the wires of the mains power cord in accordance with the following
colour coding:
Green and
Yellow
Blue
Brown
Great Britain and Australia:
Do not connect the appliance using a 13 A plug or protect it with a 13 A fuse. The appliance must be protected using
a fuse
that is rated 16 A or higher. The appliance must be disconnected from the power supply during all installation work .
When
the appliance is installed , protection must be provided against accidental contact in the future.
20
Electrical Connectors
Earth wire (E)
Neutral wire (N)
Live (L)
Warning