Important Instructions; Cleaning And Maintenance; Safety Cautions - Remington S2044 Manual Del Usuario

ENGLISH
INSTRUCTIONS FOR USE
Before use, make sure hair is clean, dry and tangle-free.
Plug in the unit, press and hold the on-off button for two seconds to switch on. Press
againfor two seconds to switch off.
To change the level of heat, press the plus or minus buttons on the top of the Straightener
For extra protection and best results, section hair prior to straightening and spray with
heat protection spray. Always straighten the lower layers first.
Run the straightener through the entire length of the hair, without stopping.
Repeat only twice per section to prevent hair damage.

IMPORTANT INSTRUCTIONS

Due to the extreme heat capabilities of this styler, extra care should be taken
when using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface.
Only hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.

CLEANING AND MAINTENANCE

Ensure the unit is unplugged and cool prior to cleaning.
Wipe clean any build up of styling products with a slightly damp cloth (do not scrub).
NOTE: Excessive use of styling products may deteriorate the TEFLON
woven fibre.
Do not use an abrasive cleaning fluid to clean, as damage will occur.

SAFETY CAUTIONS

WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
2
All manuals and user guides at all-guides.com
®