Assembly And Commissioning; Use; Pairing Of Additional Spots - Glatz OSYRION Spot Instrucciones De Montaje Y Uso

Assembly and commissioning

1
1.3
indirect
1.4
direct
1.5

Use

1
1.2
1.3
2
press
2.2
press and hold 1 sec.
2.3
Mounting on the open sunshade
1. Unpack spots
2. Check scope of delivery (page 26)
3. Select suitable rubber band (page 26)
4. Position adapter plate at suitable
place on sunshade frame
Select direct / indirect lighting
5. Tighten rubber band
!
Mount adapter plate and spot only at
locations that do not collide with either
the shade or the fabric.
!
Dispose of packaging materials properly
and keep away from children.
Do not install defective material.
In case of damage, please inform the
transport service provider immediately.
Mounting the spots
1. Open shade according to
separate instructions
2. Switch on spot (with the button on the back)
3. Mount spots
!
After 72 hours of non-use, the spot
will automatically go into sleep mode.
Switch on the spotlight using the
button on the back.
1. Control the light
To control the functions, tap the buttons
several times or keep them pressed down.
2. Switch on the light / Adjust brightness
Press button (start brightness 50%)
Press key several times, each Each press
of the button changes the brightness:
50% > 70% > 100% > 10% > 30%.
3. Switch off the light
Press and hold the key for one second.
28 29
1.3

Pairing of additional spots

press and hold
1.1
press and hold
1.2
press
1.4
3
Dismantling the spots
1. Remove the spots
2. Store in a dry place
3. Close the sunshade according to
the separate instruction manual
!
The adapter plates can remain
mounted on the sunshade when
the lighting is not in use.
!
Load the spots if necessary
1
!
Charge single spots completely
(approx. 4h) before first use.
1. Prepare the remote control
Press and hold the button for 5 seconds
(control lamp flashes)
2. Prepare the spot
Press and hold the button for 5 seconds
(spot flashes)
3. Pairing successful
The Spot shines continuously
4. Check the pairing
Press the button several times, each
button press changes the brightness
!
Maximum 8 spots per remote control.
!
The remote control remains in pairing
mode for 2 minutes or until the button
is pressed. Repeat step 3 for each
additional OSYRION Spot.
OSYRION Spot can only be paired
with one remote control at a time.