Electrolux END42396X Manual De Instrucciones página 9

8. Put the assembled tank on the door
along the valve direction.
9. Block the stopping elements in the in-
verse order of unblock.
10. Insert again the BRITA MAXTRA car-
tridge in the funnel .
How to use the BRITA MAXTRA filter
cartridge
Step 1: Preparing the cartridge
To prepare your BRITA filter cartridge, please
remove the protective wrapper (note: car-
tridge and inside wrapper may appear moist,
this is simply condensation).
Immerse the cartridge in cold water and
shake it gently to remove any air bubbles.
The filter now is ready to use.
As required for some other water filter car-
tridges, there is no need to pre-soak the new
Maxtra Cartridge.
Step 2: Insert in the water tank
Remove the tank lid. Before inserting the car-
tridge, remove the funnel and clean it thor-
oughly by rising it and wiping it dry.
Then, thoroughly clean the inside of the water
tank with a dump cloth and wipe it dry as
well.
Place the cartridge into the filter tank and
push downwards until it 'clicks' firmly into
place.
The cartridge should stay in place if the funnel
is turned upside down.
All manuals and user guides at all-guides.com
Step 3: Rinse the cartridge
2x
Take the funnel out of the BRITA water filter
unit, fill it under the tap with cold tap water
and allow it to filter through.
Discard the first two fillings into the sink.
These first two fillings are used to flush the
filter cartridge.
Then, place the funnel back into BRITA water
filter unit.
Place the cover back onto the jug and press
it carefully downwards to ensure it fits cor-
rectly into place.
Step 4: Refill the water tank
electrolux 9
3x=ok