Publicidad
Idiomas disponibles
Idiomas disponibles
At the end of the installation, it is possible to check the alarm system by carrying out the following sequence of operations,
within the first twenty seconds of immunity (Quickly flashing LED); at every test, the immunity period will be extended of
twenty seconds, in order to have enough time to perform all tests.
Setting test activities:
Open completely the driver's window. Close all doors, the trunk and the engine hood.
1.
Lock the doors by using the original remote control and wait for the open window signal (two beeps).
2.
Within 15 seconds from the previous signal, move a hand in front of the volumetric sensors and make sure of a flash
signal from the blinker.
3.
Within 20 seconds from the previous signal, unlock and open the trunk by using the original remote control; make sure
of a flash signal from the blinker and then close the trunk.
4.
Within 20 seconds from the previous signal, open the driver's door, make sure of a flash signal from the blinkers and
then close the door.
5.
Within 20 seconds from the previous signal, open the engine hood and make sure of a flash signal from the blinkers
and then close the engine hood.
6.
In order to verify the alarm deactivation trough the vehicle's original key recognition, wait the end of the immunity
period (slowly flashing LED), open one door (the alarm is triggered), turn on the ignition with the original key and make
sure that, within a couple of seconds, the alarm is deactivated (LED off).
CHECK OF THE ALARM SYSTEM
GB
Publicidad
