During Washing; Re-Selecting A Program; Add A Garment / Interrupting The Program; Canceling The Active Program - Bosch Nexxt 800 Serie Manual De Operación, Cuidado Y Instrucciones Para La Instalación

During Washing

i Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Re selecting a program
If the child lock is active, tempo
q
rarily deactivate it (see page 20).
Turn the program selector to Off.
q
Turn the program selector to a
q
newly selected program.
The Start/Pause indicator light
flashes.
If the child lock is active,
q
deactivate again temporarily.
If required, change the settings.
q
(see Page 20).
Press the Start/Pause button.
q
The program starts.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
i It is not recommended to add
laundry after the washing phase is
complete.
Without child lock
i You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
Press the Start/Pause button.
q
The following displays are
indicated in succession:
Pause",
Door can be opened".
Open the door.
q
Add/remove the laundry.
q
Close the door.
q
Press the Start/Pause button.
q
The program continues.
The indicator light is lit (red).
All manuals and user guides at all-guides.com
i When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or drum speed too high).
i If the speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Child lock activated
i
Refer to the Child Lock section,
(see page 20).
Canceling the active
program
If you would like to terminate a program
and remove the laundry:
Press the Start/Pause button
q
If Child Lock is active, it is
q
necessary to press and hold down
the Start/Pause button for five
seconds
If the load is too wet, turn the
q
program selector to Drain/Spin.
i
If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.

After Washing

The Start/Pause indicator light goes
out.
Display field: Remove laundry".
Open the door.
q
Turn the program selector to Off.
q
Close the taps.
q
Remove the laundry.
q
NOTICE
Occasionally check for any foreign
objects (e.g. coins, paper clips)
between the drum and rubber seal
- To avoid risk of rust!
i After washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.
21