Chamberlain LiftMaster 81-315LM Manual Del Propietário

Model 81-315LM Single-Button Remote Control
The 80 Series remote control works only with door
openers and light controls having a green "learn"
button and a green indicator light.
Instructions are Described and Illustrated Below
1. Press and release the "learn" button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
selected push button on the hand-held
remote.
3. Release the button when the motor unit
light blinks. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
114A2592B
All manuals and user guides at all-guides.com
OWNER'S MANUAL
9 1 9
1
7 3 7 3
5 5
KG KG
© 2006, Chamberlain Group Inc.
All Rights Reserved
WARNING
To prevent possible SERIOUS INJURY or DEATH from a
moving gate or garage door:
CAUTION
• ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate, or play with remote
controls.
• Activate gate or door ONLY when it can be seen clearly,
is properly adjusted, and there are no obstructions to
door travel.
• ALWAYS keep gate or garage door in sight until completely
closed. NEVER permit anyone to cross path of moving gate
AVERTISSEMENT
or door.
The Remote Control Batteries
ATTENTION
WARNING
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
CAUTION
• If battery is swallowed, immediately notify doctor.
The lithium batteries should produce
power for up to 5 years. To replace, pry
open case with visor clip or screwdriver,
as shown. Insert batteries positive side
up (+).
Dispose of old batteries properly.
AVERTISSEMENT
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
ATTENTION
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.