Alarm Test - x-sense XS03 Manual Del Usuario

01 02
03 04
08

Alarm Test

The alarm must be properly attached to the mounting bracket before it can be
tested.
1. Press the test button.
2. The unit beeps 3 times.
3. The red LED will fl ash once every second during the audible signal.
4. After testing, the alarm will automatically enter standby mode.
NOTE: The test function accurately tests the alarm's smoke sensing circuit without the
need to test with smoke. If your smoke alarm fails to emit an audible test signal, refer to the
troubleshooting guide at the end of this manual immediately. Never use an open fl ame to
test this device.
LED Indicator and Audible Alarm
Status LED indicator
Standby Mode Red LED flashes
once every 60 seconds.
Test Mode Red LED flashes
once every second.
Alarm Mode Red LED flashes
once every second.
Silence Mode Red LED flashes
once every 5 seconds.
Low Battery Red LED flashes once
every 60 seconds.
Audible alarm
None
3 short quick beeps
Short quick beeps
None
1 beep every 60 seconds
09