Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

RF-PCS12ES 12-outlet surge protector
5 Always-on outlets
Phone line
protection
Networking
line
protection
Protective
outlet covers
for safety
1 Master outlet
AC Adapter-spaced outlets
Coaxial cable
protection
CAUTION: Risk of electric shock. Use only in dry locations and only indoors.
DO NOT plug into another relocatable power tap. DO NOT "daisy chain" surge
protectors. DO NOT use with any aquarium equipment. DO NOT use if properly
grounded outlets are not available. DO NOT install this device if there is not at least
10 meters (30 feet) or more of wire between the electrical outlet and electrical
service panel.
Features
ON/OFF Control -
switch is also a 15A breaker. When an overload occurs, it will
automatically switch off . To resume operation,ensure the overload
condition is removed and set the switch to RESET.
LED indicators
– A lit Protected amber LED indicates surge
protection is operating normally. If it is NOT lit, it may mean a
substantial surge event has occurred and the surge protector
should be replaced. A lit Grounded amber LED indicates the wall
outlet is properly grounded. If it is NOT lit, it means the outlet is not
properly grounded and another outlet should be used to ensure
full surge protection. When both amber LEDs are lit, it indicates
normal operation and full surge protection.
Master and Controlled by Master outlets
peripherals continue to draw power when in standby mode.
The Master and Controlled by Master outlet feature prevents
8 ft (2.4 m)
energy draw by automatically shutting off power to up to six (6)
Soft-Flex
TM
peripherals when the computer goes into standby mode.
power cord
with right
Note: Only connect devices to the Controlled by Master outlets that are normally
angle plug
used when the master device (e.g. computer) is operating.
To use this feature, make sure the standby function on your
computer is enabled and plug your computer into the Master
outlet, and plug peripherals (e.g. monitor, printer, scanner, and
6 Master controlled
outlets
speakers) into the Controlled by Master outlets.
When your computer goes into standby mode, power will be shut
off to peripherals plugged into the Controlled by Master outlets.
When the computer "awakens'", the surge protector immediately
supplies power to these peripherals.
To ensure this feature works properly, enable standby mode in
your computer's power management settings. For Windows,
open the Control Panel, select Power Options, then under
Settings for Power Schemes, select a system standby time period.
For Macs, open System Preferences and select Energy Saver.
For Audio/Video (A/V) application: plug the primary A/V device
(e.g. TV) into the Master outlet and plug peripherals (e.g. set-top
box, DVD player, and amplifi er) into the Controlled by Master
outlets.
Some computers continue to consume more than 10W of
power in standby mode. The Master outlet may not recognize
the standby mode, and the outlets will not shut off . If this
occurs, make sure Hibernate/ Sleep mode is also enabled on
your computer under power management settings, or check
with your computer's manufacturer.
Controls power to all outlets. The recessed
– Computer
Safety information
To ensure the safety of children and to avoid electric shock and
damage from a high-dust environment, slide the plastic outlet
cover over outlets that are not in use.
Protecting Phone/Fax/Modem
– To protect your equipment
from surges along phone/fax/modem lines, plug the phone line
from the wall outlet into the IN port and phone/fax/modem
line(s) into OUT port(s).
Protecting Coaxial Cable
- To protect your equipment from
surges, connect your coax cable from wall outlet into IN coax port
and then connect coax cable from device into OUT coax port.
Networking Protection
- Plug a network cable from your
network's hub, switch, or router into the network IN port, and
connect the network cable from your computer into the network
OUT port.
Specifi cations
Four (4) AC Adapter-spaced Outlets
Telephone/Fax protection (RJ11): 1 In / 2 Out
Network protection (RJ45): 1 In /1 Out
Coax protection (F): 2 In / 2 Out
8ft (2.4m) Soft-Flex™ power cord with right-angle plug
4350 Joules rating
Connected equipment warranty: $500,000
Continuous Duty Electrical Rating: 15A / 125V / 1875W
Maximum Energy Dissipation and H-N / H-G / N-G
values: 4350J / 210,000A
Maximum Spike Current: 6,000V / 210,000A (H-N 90,000A; H-G
30,000A; N-G 30,000A)
UL Clamping Voltage: UL 1449/ 330V(L-N) 400V(L-G,N-G)
Response Time: Less than 1 nanosecond
EMI/RFI Noise Filtration: 150K Hz - 100M Hz, Up to 58dB
One Year Limited Warranty
Visit www.rocketfi shproducts.com for details
RoHS compliant
ENGLISH 09-0260

Publicidad

loading

Resumen de contenidos para RocketFish RF-PCS12ES

  • Página 1 Features Safety information RF-PCS12ES 12-outlet surge protector To ensure the safety of children and to avoid electric shock and ON/OFF Control - Controls power to all outlets. The recessed damage from a high-dust environment, slide the plastic outlet switch is also a 15A breaker. When an overload occurs, it will cover over outlets that are not in use.
  • Página 2 Témoins DEL : une DEL de protection ambre allumée indique Informations sur la sécurité Parasurtenseur à 12 prises RF-PCS12ES que le parasurtenseur fonctionne normalement. Si elle n’est Pour assurer la sécurité des enfants et éviter des chocs électriques PAS allumée, il se peut qu’une surtension importante se soit ou des dommages inhérents aux conditions poussiéreuses, faire...
  • Página 3 Conmutador de Encendido/Apagado (ON/OFF): controla la puede no reconocer el modo de suspensión, y las salidas no 12 salidas - RF-PCS12ES alimentación de todas las salidas. El conmutador integra también se cortarán. Si esto se produce, asegúrese de que el modo de un cortacircuitos de 15 A.