Rockford Fosgate P560 Guia Del Usuario página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Performance Specifications
A: Watts: 530W RMS
Satellites – 75W watts/ch x 5 @ 8 ohm – 10% THD
Subwoofer – 155Watts @ 4 ohm – 10% THD
B: Speakers size:
Satellites – 4.3" (W) x 3.7" (D) x 7.0" (H)
Center Satellites – 6.5" (W) x 3.7" (D) x 4.0" (H)
Subwoofer – 11" (W) x 13" (D) x 11.5" (H)
C: Drivers size:
3" dynamic satellite drivers
8" poly-carbon high excursion sub
D: Frequency response: 28Hz – 20KHz
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modi cations not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
 
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
 
residential installation.
 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure
condition without restriction.
Wall Mounting
You can mount your satellite speakers with the appropriate hardware (not included).
• Do not mount the speakers on thin plywood or on a wall with a soft surface material. The speakers may fall, possibly
damaging the speakers or causing personal injury.
• Do not affix the speakers to a wall using nails, adhesives, or unstable hardware. Long-term use and vibration may cause
the speakers to fall.
• To avoid accidents resulting from tripping over loose speaker cables, affix the cables to the wall and floor.
• Mount the speakers in a wall location that will be less likely to result in injury to an individual's head or property damage.
Warranty
For warranty information and registration, please go to www.cyberacoustics.com/rockford
All manuals and user guides at all-guides.com
12

Publicidad

Tabla de contenido
loading

Tabla de contenido