Publicidad
Idiomas disponibles
Idiomas disponibles
JUNO 2" LED RECESSED HOUSINGS
2CPNC/2NCHSG HOUSING INSTALLATION
FIXTURE INSTALLATION
Step 9. Slide mounting frame, wiring compartment first, thru
ceiling cut-out (Fig. 8).
Step 10. Align frame over opening so that 4 tabs center the
fixture in the hole (Fig. 9).
Step 11. Pull ceiling clamps back thru ceiling opening.
Position the feet on the room side of the ceiling and tighten
clamping screw to secure the frame to the ceiling. DO NOT
OVER TIGHTEN! The clamps only need to be tight enough to
positively hold the frame in location. Over tightening the screw
will lead to damage to the ceiling and loss of function of the
ceiling clamps.
Step 12
Loosen 2 screws and remove top cover from LED trim
module. Plug in connector. DO NOT ALLOW LED TRIM
MODULE TO HANG FROM THIS CONNECTION (Fig. 10).
Step 13
Place connection back in top of LED trim module.
Secure armored cable in "U" shaped opening of top cover and
tighten screws to secure cover in place (Fig. 11).
Step 14
Orient flats of heatsink to the ceiling clamps and slide
module into mounting frame until secure (Fig. 12).
WARRANTY
5-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Technical Services Phone (888) 387-2212
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-recessed
©2017 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
Figure 8
Rev 1/19
P6167
Alignment
Tabs
LED Trim
Module
Figure 10
Figure 11
Ceiling
Clamp
Heatsink
Flat
Figure 12
Clamping
Screw
Ceiling
Clamp
Figure 9
Rotate
heatsink to
align flats
2 of 2
Publicidad
