Playing A Cd Or Mp3; Repeat And Proggrammed Play; Repeat Play; Programmed Play - Lenco SCD-36 USB Manual Del Usuario

All manuals and user guides at all-guides.com
be sure to take out the CD from the player.
· If the CD does not play on batteries, this means the batteries are almost used up.
But the radio may continue to play on these weak batteries because it uses less
power than the CD player.

6.PLAYING A CD or MP3

(1) Connect the supplied AC power cord or batteries.
(2) Slide the FUNCTION switch to CD/USB/AUX IN position
(3) Open the CD door and place a disc in the CD compartment with the label side up.
(4) Close the CD door, the unit will play the disc.
(5) Press the PLAY/PAUSE button in play mode to pause the playback. Press the
PLAY/PAUSE button again to resume the playback.
(6) Adjust the VOLUME control to your preference.
(7) Press the STOP button to stop the playback.
(8) Slide the FUNCTION switch to OFF position to turn off the power.
NOTE:
" no" will show in the display if there is no disc in the CD compartment or if the disc is
upside down.
Max suppor 256 Folder, max track 1024 for DISC
Max support 999 Folder, max track 9999 for USB.
If a DISC or a USB have contain 1224, it will show C 24, the A means 10, B means 11,
C means 12, D means 13, E means 14, F means 15, the mostly to show track 1599.

7.REPEAT AND PROGGRAMMED PLAY

7.1 Repeat play

(1) Press the REPEAT button once to play the current song over and over.
(2) Press the REPEAT button twice to repeat playing all the songs in order.

7.2 Programmed play

In STOP mode,you can make a program of up to 20 tracks in the order you want them to
be played.
(1) Slide the FUNCTION switch to CD/USB/AUX IN position,make sure the CD is stopped.
(2) Press the PROGRAM button. The program number " Pro o1" will flash on the LCD .
(3) Press the PREV/NEXT button to select the desired track then press the PROGRAM
button to confirm.
(4) REPEAT step 3 to program other tracks till you finish ( up to 20 tracks)
(5) Press the PLAY/PAUSE button to start programmed play.
To play all the programmed tracks repeatedly
Press the REPEAT button in program play mode.
To change the current program
Just create a new program following the programming procedure.
To cancel programmed play
Press the STOP button twice or slide the FUNCTION switch to OFF position.

8. PLAYING OTHER AUDIO DEVICES THROUGH YOUR SET

You can enjoy the music of a digital MP3 player, computer or any other external audio
device(with a 3.5mm stereo jack)through the set.
7