Joie gemm and juva child restraint attachment to i-Base Manual De Instrucciones página 6

Installing with Base
see images -
5 17
a. Installation with 3-point-belt
see images -
5 11
1. Unfold the load leg from storage compartment.
2. After placing the base on the vehicle seat, extend the load leg to
floor , the load leg indicator shows green means it is installed
6
correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator
shows red this means the load leg is in the wrong position.
!
Make sure the load leg is secure by pressing down on the front
of the base.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
3. Open the lock-off and route the vehicle safety belt through the
-1
belt path , and lock it into the buckle.
7
4. Tighten the vehicle safety belt as much as possible while pushing
down on the base, and check it is not loose or twisted, then close
-3
the lock-off.
7
! The infant child restraint can not be used if the vehicle safety
belt with female buckle is too long to tie the base.
! Check that the safety belt does not move by pulling and pushing
hard on base. If belt loosens or lengthens, repeat procedure.
9
5
-3
6
-2
7
-4
7
5
6
1
2
7
1
2
3
3
4
10