Allen + Roth 9006BNMV Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1.
Fasten mounting brackets (BB) to shelf (A) and towel
bar (B) with hex-head screws (AA).
NOTE: Drain holes located on towel bar (B) should
be on the bottom.
2.
Hold the unit at the desired position on the wall.
NOTE: Make sure the unit is level.
Mark mounting points on wall through holes in the
mounting brackets (BB). Hammer wall anchors (CC)
into wall, unless mounting screws (DD) will go directly
into a stud.
NOTE: Do not use a wall anchor if mounting screw
will be going into a stud.
Wall anchors (CC) should be oriented with the flat
side horizontal. Place unit against wall, lining up
holes in wall and holes in mounting brackets (BB).
Complete mounting by tightening mounting screws
(DD) into studs or wall anchors (CC).
AA
Hardware Used
AA
Hex-Head Screw
BB
Mounting Bracket
CC
Hardware Used
CC
Wall Anchor
DD
Mounting Screw
3
Fig. 1
A
B
BB
Fig. 2
DD
x 4
x 2
BB
x 4
x 4
IS9007-I2