Tabla de contenido
Publicidad
leaf blower/garden vacuum. Never attempt to use an
incomplete leaf blower/garden vacuum or one with an
unauthorized modification.
● While operating the leaf blower/garden vacuum always be
sure of a safe and secure operating position at all times.
● Always be aware of your surroundings and stay alert for
possible hazards that you may not hear whilst operating the
leaf blower/garden vacuum.
● Do not over reach and keep your balance at all times.
● Always be sure of your footing on slopes.
● Walk, never run.
● Keep all cooling air inlets clear of debris.
● Never blow debris in the direction of bystanders.
● Do not carry the machine by the cable.
● The wearing of a face mask is recommended.
● Wear safety goggles.
● Do not modify this product. Unauthorized modifications may
impair the safety of your product and may result in increased
noise and vibration.
● Do not vacuum solid objects such as big branches, broken
glass, pieces of metal and stones.
● A worn fan or blower housing (chips, cracks, nicks) may
cause an increased risk of injury from thrown foreign objects. If
the blower housing is damaged, consult the Local hotline.
Remove the plug from the socket:
–Whenever you leave the machine.
– Before checking, clearing a blockage or working on the leaf
blower/garden vacuum.
– After striking a foreign object, inspect the leaf blower/garden
vacuum for damage and make repairs as necessary.
– If the leaf blower/garden vacuum starts to vibrate abnormally
check immediately.
Connecting to the mains
● The voltage indicated on the rating plate must correspond to
the voltage of the power source.
● We recommend that this equipment is only connected into a
socket which is protected by a circuit-breaker that would be
actuated by a 30 mA residual current.
● Only use or replace power supply cables for this unit which
correspond to the types indicated by the manufacturer. See the
operating instructions for the order no. and types.
● Never touch the mains plug with wet hands.
● Do not run over, crush or pull the power supply cord or
extension cord, otherwise it may be damaged. Protect the cable
from heat, oil and sharp edges.
● The extension lead must have a cross section in accordance
with the operating instructions and be protected against
splashed water. The connection must not be in water.
Electrical Safety
● Motor Protector fitted! Motor fitted with safety overload
protection. If motor stops working, allow a few minutes to
cool, before restarting.
● Warning! Switch off, remove plug from mains before
adjusting, cleaning or if cable is entangled.
● If a cord becomes damaged during use, disconnect the
supply cord from the mains immediately. DO NOT TOUCH
THE CORD BEFORE DISCONNECTING THE SUPPLY.
Your machine is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz (for
non-EU countries 220 V, 240 V as applicable). Only use
approved extension cables. Contact your Local Service Centre
for details.
Extension cords/leads should only be used if they comply with
H05VV-F, H05RN-F types or IEC type design (60227 IEC
53, 60245 IEC 57).
If you want to use an extension cable when operating your
product, only the following cable dimensions should be
used:
– 1.0 mm2: max. length 40 m
– 1.5 mm2: max. length 60 m
– 2.5 mm2: max. length 100 m
Note: If an extension cable is used it must be earthed and
connected through the plug to the earth cable of your
supply network in accordance with prescribed safety
regulations.
If in doubt contact a qualified electrician or the nearest
Local Service Centre.
● WARNING! Inadequate extension cables can be
dangerous. Extension cable, plug and socket must be
of watertight construction and intended for outdoor
use.
It is recommended for increased electrical safety to use a
Residual Current Device (RCD) with a tripping current of
not more than 30 mA. Always check your RCD every time
you use it.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if in
perfect condition. If the supply cord is damaged, it must be
replaced by a Local Service Centre.
For products not sold in GB:
WARNING: For your safety, it is required that the plug
attached to the machine is connected with the extension
cord. The coupling of the extension cord must be protected
against splash water, be made of rubber or coated with
rubber. The extension cord must be used with a cable
strain relief.
● Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place by an
authorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only:
Use a residual current device (RCD) with a rated residual
current of 30 mA or less.
Maintenance
● Keep all nuts, bolts and screws tight to ensure that the
leaf blower/garden vacuum is always in a safe working
condition.
● The leaf blower/garden vacuum should be stored in a
dry, high or locked up place out of the reach of children.
● Replace worn or damaged parts for safety.
● Check the collection bag frequently for wear or
deterioration.
● Do not attempt to repair the machine unless you are
qualified to do so.
● Ensure replacement parts fitted are Local approved.
5
Publicidad
Tabla de contenido
