Publicidad
Step 9
IMPORTANT: Your Hutch must be attached to the 404944
å
Credenza as indicated in Steps 9 and 10.
Remove the Keyboard Drawer from the Credenza. To do so, push
å
the black lever in and pull the Slide from the Rail.
Carefully position the Hutch on top of the Credenza. Fasten the
å
BACKS (J and K) to the back edge of the Credenza Top. Use
twelve BLACK 9/16" LARGE HEAD SCREWS (DD).
NOTE: You will need to make the four holes in the bottom surface
å
of the Credenza Top into through holes. Use a little extra force to
turn a BLACK 1-7/8" FLAT HEAD SCREW (BB) through the holes
in the Credenza Top to break through the surface. Then, pull the
SCREW out of each hole to clean the hole of debris.
Fasten the UPRIGHTS (C and D) to the Credenza Top. Use four
å
BLACK 1-7/8" FLAT HEAD SCREWS (DD).
K
BLACK 9/16" LARGE HEAD SCREW
(12 used for the BACKS)
www.sauder.com/services
All manuals and user guides at all-guides.com
J
9 4 4
4 0 4
z a
d e n
C r e
DD
BLACK 1-7/8" FLAT HEAD SCREW
(4 used for the UPRIGHTS)
404975
D
C
BB
Page 13
Publicidad
