Indesit IDL 750 Manual De Instrucciones página 3

Connect the outlet hose (without bending it) to a drain duct
with a minimum diameter of 4 cm. Alternatively, rest it over a
sink or tub; the free end of the hose should not remain
immersed in water.
A
We advise against the use of hose extensions.
Before inserting the plug into the electrical socket, make sure
that:
• the socket is earthed and complies with current
regulations;
• the socket can withstand the maximum load of the
appliance, which is indicated on the data plate located on
the inside of the door ( see Description of the appliance );
• the power supply voltage falls within the values indicated
on the data plate on the inside of the door;
• the socket is compatible with the plug of the appliance. If
this is not the case, ask an authorised technician to
replace the plug ( see Assistance ); do not use extension
cables or multiple sockets.
Once the appliance has been installed, the power supply
cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be
replaced by the manufacturer or its Technical Assistance
Service in order to prevent all potential hazards. (See
Assistance)
The Company shall not be held responsible for any
incidents that occur if these regulations are not observed.
The special plastic elbow*
makes it easier to find the best
layout: fix the elbow to the wall
securely in order to prevent the
outlet hose from moving and
spilling the dirty water.
The part of the hose marked
with the letter A should be
between 40 and 100 cm above
the ground ( see figure ).
After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add approximately 2 kg of salt ( see Rinse aid
and refined salt ). The water may overflow: this is normal and is
not a cause for concern. It is also normal that the LOW SALT*
indicator light continues to flash for a few cycles after the salt
has been loaded.
If the salt container is not filled, the water softener and the
heating element may be damaged as a result.
width 60 cm
Dimensions height 85 cm
depth 60 cm
Capacity 12 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
Water supply
pressure 4.3 psi – 145 psi
Power supply
See appliance data plate
voltage
Total absorbed
See appliance data plate
power
Fuse See appliance data plate
This dishwasher conforms to
the following European
Community Directives:
-73/23/EEC dated 19/02/73
(Low Voltage) and subsequent
modifications
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent modifications
-97/17/EC (Labelling)
-2002/96/ CE Waste Electrical
and Electronic Equipment
(WEEE)
* Only available in selected models.