Optional Accessories - Makita DML801 Manual De Instrucciones

Installing or removing battery cartridge
(Fig. 1)
• Always switch off the tool before installing or removing
of the battery cartridge.
• To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
• To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If you can see the red indicator
on the upper side of the button, it is not locked
completely. Install it fully until the red indicator cannot
be seen. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
• Do not use force when installing the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Battery protection system
The protection system is equipped, which automatically
cuts off the output power for its long service life. The light
goes off during operation when the remaining battery
capacity gets low. This is caused by the activation of
protection system and does not show the light trouble.
Remove the battery cartridge from the light and charge it.
Use of non-genuine Makita batteries, or batteries that
have been altered, will void the Makita warranty for the
Makita tool and charger.
Switch action (Fig. 2)
CAUTION:
• Do not look in the LED light or see the source of light
directly.
The LED light has a cycle of the three-ways status as
follows.
Switch action
1st press
2nd press
3rd press
Head angle
The head can be turned in seven stages for every 45°.
(90° to the right and 180° to the left) (Fig. 3)
And the head angle can be folded between 0 and 180° for
every 30°. (Fig. 4)
Strap
Install the strap on the tool. (Fig. 5)
Metal hook
Pivot the metal hook upright before using it. (Fig. 6)
The hook can be turned at 360°. (Fig. 7)
MAINTENANCE
CAUTION:
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
Light status
All LED lights are on.
Only 6 LED lights are on.
All LED lights are off.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. The accessories or
attachments should be used only in the proper and
intended manner.
• Makita genuine battery and charger
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
5