Storage Procedure; Warranty Policy - Harry 721 Manual De Instrucciones Y De Mantenimiento

CLUTCH LINKAGE
The new gearbox available on all walk-behind selfpropelled lawn
HARRY
mowers, has a very smooth drive engangement, due to its exclusive oil
bath clutch.
Everything works well provided the load on the clutch is right: the load is
controlled through the spring A, at the upper end of the cable B, connecting
the gearbox G (inside the lawn mower) to the engagement handle
(mounted on the upper end of the lawn mower handle)

8) STORAGE PROCEDURE

Storage procedure:
Take the following steps to prepare your mower for storage at the end of
the mowing season. Refer to the engine manual for directions for preserving
the engine. With the spark plug wire disconnected from plug, turn the
mower on its side and thoroughly clean underside of deck. Scrape away
accumulation of grass with putty knife and/or wire brush first, then wash
down with water from a hose.
CAUTION: Avoid spraying water into exhaust or air intake while washing
deck - tape openings closed to prevent this. Clean external surfaces of
mower and allow to dry, then lubricate all exposed metal surfaces with a
light coating of oil to prevent corrosion. The grass catcher may be washed
in detergent; allow to dry thoroughly after washing. Store mower during
off season in a storage shed or dry area protected from weather.
All manuals and user guides at all-guides.com
To check and correct (if necessary) the tension on the spring A, the following
sequence should be followed:
1 Check the length (L
2 Pull the engagement handle into "engaged" position (engagement
3 When: (L
4 If (L

9) WARRANTY POLICY

HARRY
after sales service on lawn mowers.
HARRY
parts manufactured by them which, in normal use are found upon
examination by Manufacturer's Authorized Service Dealer or at the
Manufactur's Factory, to be defective in material and/or workmanship.
The warranty is effective from the date of purchase of the lawn mower
and extends for one year.
The warranty shall be effective only if this booklet is properly filled in
below and if the purchaser, when requesting a warranty repair to the
Service Agent, will present this booklet properly filled. All carriage charges,
damage or loss incurred during transit shall be borne by the purchaser.
The purchaser must also bear the cost of cleaning and normal maintenance.
NO REGISTRATION (WARRANTY) CARD IS NECESSARY TO OBTAIN
WARRANTY ON
INFORMATION AND RETAIN FOR YOUR RECORD:
Lawn Mower Model No.
Date
) of the spring A, when the engagement handle is
0
in "dis-engaged" position (engagement bar far away from lawn mower
handle).
handle as close as possible to the upper part of lawn mower handle)
and check the length (L ) of the spring A.
1
- L ) = 0.47 (+ 0.04") the spring tension is right.
1 0
- L ) is lower or higher than 0.47", the spring tension must be
1 0
corrected as follows:
4.1 Prevent rotation of cable B throught hexagon C.
4.2 Loosen and rotate nuts D and E until (L
4.3 Re-tighten bolts D and E to bracket F, in order to make sure the
spring tension cannot alter while working.
through its service network provides all customers with an efficient
will repair without charge to the original purchaser only part or
LAWN-MOWERS. FILL IN THE REQUIRED
HARRY
HARRY
- L ) is close enough to 0.4".
1 0
11