After Use - Würth 0891 385 009 Manual Del Usuario

The oaming result an e strongl
in uen ed
o small mi ing plates fitted in the no le,
and dependent on the oaming agent.
▸
elease the Lever o the shut o valve [4].
pra ing ends.
3
▸
the idth o the oam de reases signifi antl ,
pump up again.

After use

Note
serve the notes in the sa et
ever allo li uid to get into the devi e.
a t
The devi e does not uild up
an pressure.
Li uid es apes out o the
pump.
Piston manometer indi ates
no ontainer pressure, sa et
valve lo s o too earl .
o le does not spra , even
though pressure is available.
hut o valve does not lose.
Li uid es apes ithout a tiva-
tion of the lever.
No foam formation.
16
pressure and the num er
se tion.
Cause
Pump not s re ed in tightl .
O-ring [11] on the pump de e -
tive.
Sleeve [12] de e tive.
Valve dis [13] dirt or de e -
tive.
Piston manometer [7] de e -
tive.
Filter
and/or no le [14] and/or small
mi ing plates [15]
logged.
O-Rings [17] of the pressure
pin [18] not greased/lu ri at-
ed.
Piston pin [18] or O-rings [17]
de e tive.
Rising tube [8] separated rom hose.
Rising tube [8] position not OK.
▸
Pull the red kno o the piston manometer [7] up
until the ontainer is depressurised.
▸
Lo k the plunger ith handle [9].
▸
Screw the pump [2] out of the container.
▸
ill the ontainer ith ater and spra it out or
the purposes of cleaning.
▸
ipe o the devi e using a damp loth.
▸
To dr and store, store the ontainer [1] and
pump [2] separatel in a dr , rost ree environ-
ment, shielded rom sunlight.
▸
t
nt
a t
Replace O-ring.
Replace sleeve.
Replace the piston manometer.
small mi ing plates.
sure-pin.
Replace pressure pin or O-ring.
.
Screw the hose [3] a k into the
container.
an t ot t
re the pump in tightl .
lean or repla e valve dis .
lean filter and/or no le. epla e
rease the ring o the pres-
onne t rising tu e/hose.
-