Connecting The Power - Dymo Rhino 6000 Guia De Inicio Rapido

2. Connecting the power

The label printer can operate using the rechargable battery pack or the AC power
adapter. For temporary backup power, six AA alkaline batteries can be used.
To charge the battery pack the first time you
use the printer, insert the battery pack and plug
in the power adapter. Charging the battery
pack the first time takes approximately eight
hours. Recharging the battery pack will take
approximately two hours.
To insert the battery pack
Remove the battery compartment cover.
1.
See Figure 2.
Insert the battery pack into the battery
2.
compartment.
Replace the battery compartment cover.
3.
To connect the power adapter
Plug the power adapter into the power
1.
connector on the bottom of the printer.
See Figure 3.
Plug the other end of the power adapter
2.
into a power outlet.
2
Figure 2
Figure 3