Selecting The Temperature - Sinbo SSI 2860 Manual De Uso

All manuals and user guides at all-guides.com
WEEE: This device is made of recycling materials proper to WEEE directives and for this
reason it shall not be junked. Please, apply to the nearest waste collection center to
provide the recycling this device.
SUGGESTIONS BEFORE USING THE IRON FOR THE FIRST TIME
1. Certain parts of the iron have been lightly greased therefore the iron could give off a
little smoke when plugged in for the first time. This will cease after a short while.
2. Before using the iron for the first time , remove the plastic protector from the base(if
it has one) clean the base with a soft cloth.
3. Keep the base very smooth. Do not run it over metal objects (such as against the
ironing board, buttons , zips ,etc.)
4. Pure wool fibres (100% wool)can be ironed with the appliance in the steam position
.by preference ,select a high steam position and use a dry ironing cloth.

SELECTING THE TEMPERATURE

1. Check the ironing instructions on the garment to be ironed.
2. If the garment does not have any ironing instructions but you know the kind of fabric
in question, use the chart below.
3. Fabrics that have some kind of finish(polishing . wrinkles , contrasts....)can be ironed
at the lowest temperatures.
4. If the fabric contains several kinds of fibres ,always select the temperature applicable
,if an article contains 60% polyester and 40% cotton ,you must always choose the
temperature corresponding to polyester and without steam.
5. First classify the articles to be ironed according to the most suitable ironing temperature
: wool with wool, cotton with cotton, etc. as the iron heats up as fast as it cools , start
by ironing the articles requiring the lowest temperature such as those made of synthetic
fibres . Progress towards those that require the highest temperatures.
6. Turn the temperature control until it is in front of the appropriate signal according to
the following:
• position for nylon and acetate
•• position for wool ,silk or mixures
••• position for cotton or linen (steam).
HOW TO FILL THE WATER TANK.
1. Unplug the iron.
2. Set the steam ruler to dry ironing .
3. Fill the tank through the filling hole.
- If you have hard water ,it is advisable to use only distilled or demineralized water.
- do not use chemically de-limed water or perfumed
4. Do not store the iron with water in the tank.
- 9 -