Before You Start - Costway HW66549 Manual Del Usuario

Contact Us!
Do NOT return this item.
Contact our friendly customer service department for help first.
E-mail
US: cs.us@costway.com
UK: cs.uk@costway.com

Before You Start

Before You Start
Please read all instructions carefully.
Retain instructions for future reference.
Separate and count all parts and hardware.
Read through each step carefully and follow the proper order.
We recommend that, where possible, all items are assembled near to the
area in which they will be placed in use, to avoid moving the product
unnecessarily once assembled.
Always place the product on a flat, steady and stable surface.
Keep all small parts and packaging materials for this product away from
babies and children as they potentially pose a serious choking hazard.
02
www.costway.com
OPERATING INSTRUCTIONS
Please do not keep emergency override keys in your safe!
(factory setting code is "123456")
1.Open The Safe Box for The First Time or Emergency Open
Insert the emergency override key into the keyhole, and turn the key in
counter-clockwise direction. At the same time, turn the knob of control panel
clockwise direction to open your safe.
2. Installation and Replacement of the Battery
After opening your safe, push the battery cover plate on the back of the door,
install the batteries. (Please install the anode and cathode of the battery
correctly).
3. PROGRAMMING THE CODE
A. With the door open, press "00" and press the red button (reset button) on
the back of the door near the hinge, release it and you will hear one "tick".
The panel shows "Right" and flashes.
B. Enter new password (3-8 numbers), and confirm by pressing "#" (eg.
"123456#"). You will hear long "beep". The new password was set up.
Write down your new password immediately and check whether your new
combination has been programmed.
4. PROGRAMMING THE FINGERPRINT
A. With the door open, press the red button (reset button) on the back of the
door near the hinge, release it and you will hear two "tick". The panel lights
up and the fingerprint lamp flashes, put your finger on the senor(press hard)
and take away, do like this four times, each time you will hear one "beep".
Then, you will hear one long "beep". It means you have registered the
fingerprint successfully. If not, press your finger again until you succeed.
B. If you hear three beeps and LED lamp flashes three times when you press
the red button, it means your fingerprint memory is full.
C. The storage capacity of fingerprint is 30.
www.costway.com
03