Bitronvideo B-FAST AV1407/005 Manual De Instrucciones página 8

* (Video cyclic and video transfer are functions supported by the system, but for door phone they haven't
any visual effect).
INTERCOM FUNCTION IN THE SAME APARTMENT
1. Go to the door phone to be programmed as caller (door
phone'c1').
2. Hold the door opener button pressed and pick up the
handset. The door phone "c1" emits a tone to signal
the access to button programming mode for intercom
function.
3. Press the button"•"; the door phone
confi rmation tone (also the buttons in the additional
button module can be programmed in the same way).
4. Go to the door phone or monitor that the button must
call (door phone or monitor 'c2') and press the door
opener button. The calling door phone and the called
door phone or monitor 'c1' and 'c2' will beep to signal
that they have been programmed.
5. Hang up the handset of calling door phone'c1', that will
beep to indicate the exit from programming mode.
6. Check immediately the programmed function:
Hang up the handset of door phone 'c1' and press the
programmed button. Check that all door phones or
monitors of user 'c2' ring; hang up the handset of a
door phone or monitor 'c2' and check that it is possible
to communicate with door phone 'c1'.
7. If you want to make the inverse call from'c2' to 'c1', it is necessary to programm also the door phone or
monitor 'c2' to call the door phone 'c1' as described in the previous sections.
If the button"•" is programmed for intercom function, the auto-on functions will not be lost (video cyclic
and video transfer*), because these are performed when the handset is on hook.
* (Video cyclic and video transfer are functions supported by the system, but for door phone they haven't
any visual effect).
14
All manuals and user guides at all-guides.com
'c1'
'c1' emits a
'c1'
'c2'
FLOOR CALL TONE
5 call tones can be selected for door phones of B-fast
system. The selection is made by the end user by following
the simple steps below:
1. Hold the door opener button pressed; press and release
the button "•". The door phone will play a tone.
2. Hold the door opener button pressed and press again
the button"•" to change the tone.
3. Release the door opener button when the desired tone
has been selected. The tone is programmed.
DOOR PHONE OR INTERCOM CALL TONE
As for the fl oor call tone, the door phone of Bfast series can select one of the 5 door phone call tones. To
perform this programming it is necessary to open the door phone and connect a button to terminal pins A+ and
A-. See terminal pins description in the connections chapter. After making the connection, go on as described
in the previous chapter by using the connected button instead of "•" button.
PROGRAMMING DATA DELETING
To delete all optional programming data perform as follows:
1. Access programming mode as shown in the "Door phone intercom function" paragraph
(Hold the door opener button pressed, pick up the handset and then release the door opener button).
2. Press at the same time the buttons "•" and the auxiliary button connected between terminal pins A+
and A- for 3 seconds at least, or until the loudspeaker emits a tone. See terminal pins description in the
connections chapter.
3. Release the buttons and hang up the handset.
DS90330-003A DS90330-003A 15