Lanaform Aroma Zen Manual Del Usuario página 6

1) Using boiled and cooled water for each application,
EN
2) Cleaning the reservoir every 2 days and cleaning the transducer each week.
3) Changing the water in the reservoir regularly. Don't leave it there for more than 2 days.
4) Cleaning the whole Aroma Zen (see the explanation below) and making sure that all the parts are completely dry
when it is not being used.
Cleaning the transducer:
1) Place 2 to 5 drops of vinegar on the surface and leave for from 2 to 5 minutes.
2) Brush the scum off the surface using a soft brush. Don't use a hard tool to scratch the surface.
3) Rinse the base reservoir in clean water.
4) Do not use soap, solvent or a spray on cleaning agent to clean the transducer.
To clean the water tank:
1) Clean the water tank using a soft cloth and with vinegar if there is scum OR limescale inside.
2) If the safety cut-out is covered in scum, put a few drops of vinegar on it and clean it with the soft brush.
3) Rinse the water tank in clean water.
Storage:
Store the device in a clean, dry place, out of the reach of children, having cleaned and dried it.
BREAKDOWNS AND SOLUTIONS
If the Aroma Zen does not operate properly under normal conditions of use, consult the following table:
BREAKDOWNS
No blowing, no vapour,
no indicator lights
Blowing, but no vapour.
Vapour with an unusual
smell.
6
POSSIBLE CAUSES
If there is no light.
Main switch off.
The water level in the reservoir is too high
(>100 ml).
Water is leaking from the reservoir.
No water in the reservoir or the reservoir
does not contain more than 20 ml.
The temperature of the unit is too low.
Water has been stagnating for too long in
the reservoir.
SOLUTIONS
Check the device is plugged in or that there
is not a power failure.
Switch on the main switch.
Remove some water from the reservoir.
Check that the lids are closed properly.
Fill the reservoir.
Place the unit in a room at ambient
temperature for half an hour before use.
Clean the reservoir and fill it with fresh
water.