After Use - Tarrington House MAC2320C Manual Del Usuario

All manuals and user guides at all-guides.com
Mode selection button
Press to select mode. Mode
switches from Auto to air
conditioning, dehumidifying,
fan and (for some models)
heating mode. The respective
indicator lights up.
Notes:
• In Auto mode, appliance
automatically operates in
air conditioning, heating
or fan mode according to
room temperature and set
temperature. Fan speed
cannot be adjusted.
• In dehumidifying mode,
fan speed and temperature
cannot be adjusted.
Appliance will operate on
low fan speed and at 25°C
temperature.
• In fan mode, temperature
cannot be adjusted.
Appliance will operate at
25°C temperature.
Fan speed button (only for
air conditioning, heating and
fan mode)
Press to adjust fan speed.
Speed will be adjusted from
Auto to high, medium and low.
The respective indicator lights
up.
Note: Auto fan speed is not
available in fan mode.
+/- buttons (only for Auto,
air conditioning and heating
mode)
• Press to adjust temperature
or to adjust time in timer
mode.
• Keep both buttons pressed
at the same time for a few
seconds to switch between
°C and °F.
• The refrigerating
compressor runs and stop
in order to maintain the set
temperature.

5. After use

• WARNING! Before cleaning, turn off and
unplug the appliance. Wait for 5 minutes after
unplugging the appliance, otherwise there is a
risk of electric shock!
• Do not clean the appliance with any strong
chemicals, alkali, abrasive or disinfecting
agents, as they may damage the surface of the
appliance.
• Do not immerse the appliance in water or other
liquids to clean it. Never hold the appliance
under running water. Make sure that no water
enters the appliance while cleaning it.
• Clean the surfaces of the appliance with a
soft damp cloth and, if necessary, a little mild
detergent. Wipe with a dry and soft cloth.
• Clean the filters with a small, soft brush or the
nozzle of a vacuum cleaner. If the filters are
very dirty, they may also be cleaned with warm
water and mild detergent. Let them air dry
completely afterwards.
• To clean the upper air filter, pull it up out of the
appliance. Reinstall it after cleaning.
• To clean the lower air filter, loosen the screw on
its cover and remove the cover. Then carefully
- 7 -
Sleep mode button (only for
air conditioning and heating
mode)
Press to switch into sleep
mode. The sleep mode
indicator will light up. Appliance
will now operate for 8 hours
and switch itself off afterwards.
Swing mode button (only for
model MAC3540C)
Press so that air outlet cover
moves up and down. The
swing mode indicator lights up.
Note: Swing mode button is
not available on remote control.
Timer button
Press to enter timer selection.
The timer indicator will light up.
When timer is set, appliance
turns itself off after set time has
passed.
Note: Press button during
operation to check remaining
time. To cancel timer, press
button again or set timer to 0.
Filter reset button
Clean filters when light on
button lights up. Make sure to
press button after cleaning.
GB