MTD products Cub Cadet 769-12285 Manual Del Usuario página 19

Safety information
¾ read and observe the operating instructions
of the power pack and the charger .
tips for use
¾ Beware of injuries to the feet and hand
caused by the cutting element .
¾ remove the power pack from the device:
- Whenever you leave the device unattended.
- Before removing blockages.
- Before checking cleaning or working on the
device.
- After impacting a foreign body to check the de-
vice for damage.
- For immediate checking if the device starts to
vibrate excessively.
¾ Do not use the device in potentially explosive
atmospheres containing flammable liquids,
gases or dusts . The trimmer may create sparks,
which could ignite the dust or vapours.
¾ Never leave the trimmer unattended during
breaks and store it in a secure location .
¾ Hold the trimmer parallel to the lawn when
switching on, otherwise there is a risk of
injury .
¾ Also when working maintain a safe distance
relative to the rotating line .
¾ Do not reach into the area of the rotating line .
¾ take care to avoid injury from the device used
for shortening the line length . After pulling
out new line, always hold the device in its nor-
mal working position before you switch it on .
¾ Wear suitable safety goggles and ear defend-
ers!
¾ Adopt a normal posture . Ensure you are
standing securely and that you maintain your
balance at all times . Pay particular attention, if
you are working on a slope. Do not run, rather
walk forwards at a steady pace. This will ensure
that you can maintain better control of the device
if unexpected situations occur.
¾ take extra care if you are walking backwards .
risk of tripping!
¾ remove the power pack when carrying the
device to or from separate working positions .
¾ Never bypass or manipulate safety devices
installed on the device .
769-12285
All manuals and user guides at all-guides.com
Safety information
¾ Do not push the line box into the ground or
hit it against wall edges . If the line box sud-
denly receives a heavy blow, be prepared for
increased vibration at the handle . If this does
occur, the device must be checked and, if neces-
sary, repaired by a qualified expert or workshop.
¾ Exercise caution when handling the plastic
knife . Risk of injury!
After use
¾ Switch the device off, remove the power pack
and check the device for damage . Attention,
danger! cutting tool still running!
¾ If you need to clean or service the device,
switch it off and remove the power pack .
¾ Always wait until the cutting tool comes to
a standstill and do not touch any moving
dangerous parts, without first removing the
power pack .
¾ removal of guards or replacement of the
line spool/knife must only be performed with
the power pack removed . Use only original
line spools/plastic knives and observe the fitting
instructions!
¾ Ensure that ventilation slots are free from dirt .
¾ Do not clean the trimmer using water .
¾ Store the device in a secure location .
¾ Store the device out of reach of children .
¾ Do not repair the device yourself; it must be
repaired by a qualified expert or workshop.
¾ Let the device cool down before putting it
away and/or storing it .
General safety information
¾ Never replace the non-metallic cutting ele-
ment with a metallic cutting element!
¾ Always wait until the cutting tool comes to
a standstill and do not touch any moving
dangerous parts, without first removing the
power pack .
EN
19