Installing The Camera - Voyager WVSXC160 Manual De Instrucciones

Installing the camera

1. Locate the Voyager technology plate on your RV shown below.
2. Remove 4 screws holding plate in.
3. Once removed, you will find the standard connector, as shown on the next page.
4. Connect the camera connector to the connector underneath the plate, as shown on the
next page.
5. Install the camera with the 4 screws used to hold the plate.
6. Camera should be adjusted for optimum view before these screws are fully tightened.
* If your RV does not have the WiSight Technology plate, use the included pigtail to tie
into 12V power from clearance lights.
1