Trouble Shooting - Parkside PAHE 20-Li B2 Traducción Del Manual De Instrucciones Original

Trouble Shooting

Problem
Device does not
start
Device works with
interruptions
Saw is having
difficulties running,
chain jumps off
Chain gets hot,
smoke develops
while sawing, the
rail changes colour
Bad cutting output
Possible cause
Discharge the battery (11)
Battery (11) not inserted
On/off switch (13) is bro-
ken
Defective motor
Internal loose contact
On/off switch (13) is bro-
ken
Insufficient chain tension
Too little chain oil
Saw chain (2) dull
Insufficient chain tension
Troubleshooting
Charge the battery (observe the se-
parate operating instructions for the
rechargeable battery and charger)
Insert the rechargeable battery (obser-
ve the separate operating instructions
for the rechargeable battery and char-
ger)
Repair by service centre
Repair by service centre
Check chain tension
Check oil level and top of chain oil if
necessary, check the oil automation
and clean the oil drainage duct as nee-
ded, or arrange for repair by customer
service
Sharpen or replace saw chain (service
centre)
Check chain tension
GB IE
47