Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CAUTION
Follow these instructions carefully,especially when fixing to the cei-
ling (if not assembled properly it can be dangerous)*, to enjoy maxi-
mum safety in the installation and performance of this equipment.
Do not throw away electrical products together along with household
waste. Please recycle the packaging at the collection points provided
for this purpose. Contact local authorities or your provider for recy-
cling advice. Thank you for recycling them at the collection points
provided for this purpose.
The installation must be carried out by qualified personnel to perform
electrical installations in accordance with the regulations in force in
the country of installation.
If the power cord is damaged, it must be replaced by the manufac-
turer, its after-sales service or similar qualified personnel in order to
avoid a danger.
Replaceable Bulb
Note: Important warnings and instructions in this manual do not guarantee
covering all possible conditions and situations that may occur. It should be
understood that common sense, caution and care are factors that cannot be
included in all products. These factors can only and should be provided by the
user who takes care of and enjoys this product
NETWORK CONECTION
1.- Screw type terminal
2.- Class II: 2 Poles (L + N) / Class I: 3 Poles (L + N + TT)
3.- Assigned Voltage 250V and Current 10A.
4.- The terminals must have a minimum capacity of 1.5mm ² for indoor lighting and 2.5mm ² for outdoor
lighting.
5.- Verify that the connection block is suitable for the output cable, either a unipolar cable or a bipolar / tripolar
cable.
6.- Check if the connection block to be included must be fixed on the luminaire. It must always be kept away
from heat sources.
7.- IP grade. It must be according to the IP grade marked on the luminaire
8.- In accordance with the EN 60998-2-1 or EN 909998-2-2 standards.
* Respect the color code according to the terminal (L = Brown, black or gray. N = Blue, Ground = Green and yellow)
* Minimum values. In cases of powers higher than 2500W, check the current to know the characteristics of the
connection lock.
* Check if the connection block requires ferrules or special preparation for a correct connection.
- The data shown in this table are merely informative and do not constitute, in any case, unique conditions of
connection to ref by the user or installer. In case of opting for another connection block, the conditions of use
that the EN 60598-1 standard establishes must be respected, highlighting the requirements of creepage distan-
ces and distances in the air for grid connection blocks.
Type A: For making connections inside Class I luminaires. The class II version is similar, but with two poles.
Type B: To make connections to the exterior of Class I luminaires. The Class II version is similar, but with two poles.
Type C: To make connections outside luminaires with class I disconnection. The class II version is similar, but with
two poles. Check that the cable diameter is suitable for the type of connection block.
Type D: To make connections outside luminaires with Grade> IP20. Check that the cable diameter is suitable for
the type of connection block.
www.sulion.es
CIF A28763647
+34 916774540
ATC: 916749481 - info@sulion.es / SAT : 916749483 - sat@sulion.es
Calle Verano, 51 - Polígono Industrial Las Monjas -28850 Torrejón de Ardoz - Madrid (ESPAÑA)
INSTALLING THE PRODUCT
SEE INSTALLATION STEPS AT THE END OF THIS MANUAL
WARRANTY
The manufacturer guarantees the proper functioning of the equipment
and possible repairs or supply of spare parts of the model due to manu-
facturing defects for 2 years from the date of delivery, but cannot be held
responsible for damages and / or damages caused by improper use of
this. For any claim, the purchase ticket must be attached to this guarantee.
The company is committed to the total free repair of the vices or defects
originated and the damages and losses directly caused by them. Likewise,
if the repair is not satisfactory and the object does not have the optimal
conditions to fulfill the intended use, the owner of the guarantee will be
entitled to the replacement of the object acquired by another of identical
characteristics or the return of the price paid. Terms and conditions of gua-
rantee in www.sulion.es/en
EC Declaration
- SULION hereby declares that the type of luminary YUKA (Ref.:400091)
is in accordance with Directive 2014/53/EU y RoHS 2011/65/UE)
The full text of the EU declaration of conformity is available on the fo-
llowing internet address: www.sulion.es/en
Publicidad
