Num'axes PIE1052 Manual De Instrucciones página 25

PIR sensitivity
PIR interval
Time Lapse
Timer 1
Timer 2
Remote control
High | Medium | Low
High sensitivity:
1) is more sensitive to movements by smaller subjects;
2) offers longer detection distance;
3) makes it easier for the PIR sensor to detect a difference between body heat and
outdoor temperature;
4) makes it easier to trigger the camera.
In high temperature environment, subjects body heat and environment temperature are
hard to tell by the camera, the suggested setting is high.
It is recommended to use low PIR sensitivity in environments with lots of interference
like hot wind, smoke, near window, etc.
OFF | ON – Default PIR interval: 20 seconds
Select "ON" then press OK to set the time interval that you desire between
photos/videos upon motion. This option avoids camera taking to many photos or videos.
Configurable PIR Interval: from 00:00:05 to 23:59:59
Example: if the PIR interval is 00:01:00, the camera will wait 1 minute between
photo/video recordings with motion.
OFF | ON
With Time Lapse set to ON, the camera will capture photos or videos automatically at a
pre-set time interval regardless of whether motions are detected or not.
Select "ON" then press OK to set the Time Lapse; the camera will shoot photos or video
clips automatically upon the set interval. Object motion can still trigger the camera to
take photos/videos if the PIR Switch is ON.
Configurable Time Lapse: from 00:00:05 to 23:59:59
Example: if Time Lapse is set to 00:30:00, the camera will automatically capture
photos/videos every 30 minutes.
OFF | ON
Each day, the camera will work only during the user set time period(s) (1 or 2).
Select "ON" then press OK to set the start time and end time of the desired working
period.
Example: If Timer 1 is set to 15:00-18:00; each day, the camera will work only between
15h00 (03:00 PM) and 18h00 (06:00 PM).
OFF | ON
Each day, the camera will work only during the user set time period(s) (1 or 2).
Select "ON" then press OK to set the beginning time and end time of the desired working
period.
Example: If Timer 2 is set to 20:00-22:00; each day, the camera will work only between
20h00 (08:00 PM) and 22h00 (10:00 PM).
OFF | Real time | Delay 0.5H | Delay 1H | Delay 2H | Delay 3H | Delay 4H |
Delay 6H | Delay 12H | Delay 24H
− OFF: remote control deactivated
− Real time (this option will consume huge battery power): the camera 4G module
is in stand-by all the time; so, the camera setups can be changed and saved
whenever you send the remote setup commands.
− Delay (option suggested for AA battery power): the camera will only be able to
change and save the setups remotely every day with a delay of ½ hour, 1 jour, 2
hours, 3 hours, 4 hours, 6 hours, 12 hours or 24 hours depending on the selected
setting. The longer the delay, the lower the energy consumption.
Guide d'utilisation PIE1052 – indice B – Février 2022 25/72